Teltonika FM3622

Teltonika FM3622 is a small professional GPS/GLONASS tracker with 3G support, internal high gain GNSS and 3G antennas, internal backup battery, 1-Wire protocol support, GNSS antenna disconnection detection, and more.

Protocol: teltonika Manufacturer: Teltonika Forum discussion
Properties
APN Name
gprs_apn_1profile
apn: APN Name
APN Password
gprs_apn_password_1profile
password: APN Password
APN Username
gprs_apn_username_1profile
username: APN Username
GPRS Content Activation
gprs_enable_1profile
enable: Enable GPRS
Dout control via ignition
ignition_controls_dout2
Once ignition status changes from ON to OFF and set timeout passes then selected DOUT is turned ON. Turning DOUT OFF is possible with a signal (voltage) applied to a configured DIN.
control: DOUT control
timeout: Ignition OFF timeout
deactivation: Dout deactivation via DIN
Immobilizer scenario parameters
immobilizer_dout2
output: Output control
timeout: Ignition OFF timeout
priority: Scenario priority
event_enable: Enable event record
Digital Outputs
outputs2
Change state of digital outputs 1 - 2
out1: Output 1
out2: Output 2
Backend Server Host
server_host_1profile
host: Host
Backend Server Port
server_port_1profile
port: Port
Backend Server Protocol
server_protocol_1profile
protocol: Protocol
Action command setdigout
setdigout_2
Send setdigout command to control digital outputs 1 - 2 with timeout and speed limit options
out1: State of digital output 1
out2: State of digital output 2
Properties
Codec 12 command
codec12
Send command encoded in Codec 12
hex: Payload is encoded as HEX string
crlf: Add CR and LF bytes after text payload
payload: Text or hex data to send
Set output 3 to ON for 5 seconds, and set outputs 1,2,4 to OFF
{"payload":"setdigout 0010 0 0 5 0"}
Custom command
custom
Send custom command via connection or over SMS
Force device to generate a record and connect to server to deliver it
{"text":"getrecord"}
Send custom bytes to device as codec 12 command. May be used to communicate with external equipment connected over serial port
{"hex":"DEADBEEF"}
Get configuration param
getparam
Get configuration parameter by its number
param: Param number
Set configuration param
setparam
Set configuration parameter by its number
param: Param number
value: Param value