Teltonika FMB110 GPS tracker

Title	Name	Description	Properties
Secondary GPRS Server Setup	backup_server		host: Host mode: Mode port: Port protocol: Secondary GPRS server protocol
CAN Parameters	can_params	CAN parameters setup.	maf: Mass Air Flow Rate cmd_egr: Commanded EGR dtc_num: Number of DTC abs_load: Absolute Load Value air_temp: Ambient Air Temperature oil_temp: Engine Oil Temperature throttle: Throttle Position egr_error: EGR Error fuel_rate: Engine Fuel Rate engine_rpm: Engine RPM fuel_level: Fuel Level intake_map: Intake MAP engine_load: Engine Load time_mil_on: Time Run With MIL On bar_pressure: Barometric Pressure battery_life: Hybrid Battery Pack Remaining Life coolant_temp: Coolant Temperature distance_mil: Distance Traveled Since MIL On fuel_pressure: Fuel Pressure vehicle_speed: Vehicle Speed module_voltage: Control Module Voltage timing_advance: Timing Advance fuel_inj_timing: Fuel Injection Timing intake_air_temp: Intake Air Temperature short_fuel_trim: Short Fuel Trim run_engine_start: Run Time Since Engine Start time_codes_clear: Time Since Trouble Codes Cleared distance_codes_clear: Distance Traveled Since Trouble Codes Cleared abs_fuel_rail_pressure: Absolute Fuel Rail Pressure dir_fuel_rail_pressure: Direct Fuel Rail Pressure rel_fuel_rail_pressure: Relative Fuel Rail Pressure
GPRS Setup	gprs	Setup sending data by GPRS link. Note: after changing this setting device will be disconnected from current server.	apn: APN Name enabled: GPRS Enabled password: APN Password username: APN Username
GPRS Server Setup	gprs_server	Setup server to send data by GPRS link. Note: after changing this setting device will be disconnected from current server.	host: Host port: Port
Green Driving	green_driving	Green driving scenario settings	sms: Send SMS prio: Priority output: Output Control source: Source duration: Duration max_accel: Max Acceleration max_angle: Max Angle max_brake: Max Braking
Home GSM Network Settings	home_network	Data acquisition parameters for home GSM network.	on_move: Vehicle Moving on_stop: Vehicle On Stop
Ignition Detection Source	ignition_detection	Ignition source is configurable and used to determine vehicle ignition status. Ignition status is used in power management and the following functionalities: eco driving, excessive idling, fuel consumption, over speeding, towing and trip.	ign: Ignition Source
LED Indication	led_indication		enabled: Enabled
Motion Detection Source	motion_detection	Object motion detection is to be configured to determine device working mode. Other functionalities that depend on movement source are: power manager, fuel consumption and trip.	source: Movement Source
Odometer	odometer_fmb	Set odometer mode and initial value	value: Initiate odometer value source: Calculation source
Digital Outputs	outputs2	Change state of digital outputs 1 - 2	out1: Output 1 out2: Output 2
Overspeeding	overspeeding	Overspeeding scenario settings	sms: Send SMS prio: Priority output: Output Control max_speed: Max Speed
Records Parameters	records_params	Records sending parameters setup.	order: Records Soring Order online: Open Link Timeout response: Server Response Timeout
Roaming GSM Network Settings	roaming_network	Data acquisition parameters for roaming GSM network.	on_move: Vehicle Moving on_stop: Vehicle On Stop
Sleep Mode	sleep_mode	Device power saving mode setup. In sleep mode module reduces level of power consumption by turning GPS module to sleep. In deep sleep mode module turns GPS module to sleep and device is deregistered from GSM network (device do not receive SMS in deep sleep). In Online Deep Sleep mode device works as in Deep Sleep mode, but without deregistering from GSM network.	mode: Sleep Mode
Static Navigation	static_filter	Static Navigation Mode is a filter, which filters out track jumps when the object is not moving.	stat_nav: Static Navigation