Teltonika FMB202 is a small and professional waterproof GLONASS/GPS tracking device with Bluetooth support and a 400mAh internal Ni-MH battery. The device features a 1-Wire interface, digital I/O, 6-30V power supply, and IP67 casing.
Title | Name | Description | Properties |
CAN Parameters | can_params | CAN parameters setup. | maf: Mass Air Flow Rate cmd_egr: Commanded EGR dtc_num: Number of DTC abs_load: Absolute Load Value air_temp: Ambient Air Temperature oil_temp: Engine Oil Temperature throttle: Throttle Position egr_error: EGR Error fuel_rate: Engine Fuel Rate engine_rpm: Engine RPM fuel_level: Fuel Level intake_map: Intake MAP engine_load: Engine Load time_mil_on: Time Run With MIL On bar_pressure: Barometric Pressure battery_life: Hybrid Battery Pack Remaining Life coolant_temp: Coolant Temperature distance_mil: Distance Traveled Since MIL On fuel_pressure: Fuel Pressure vehicle_speed: Vehicle Speed module_voltage: Control Module Voltage timing_advance: Timing Advance fuel_inj_timing: Fuel Injection Timing intake_air_temp: Intake Air Temperature short_fuel_trim: Short Fuel Trim run_engine_start: Run Time Since Engine Start time_codes_clear: Time Since Trouble Codes Cleared distance_codes_clear: Distance Traveled Since Trouble Codes Cleared abs_fuel_rail_pressure: Absolute Fuel Rail Pressure dir_fuel_rail_pressure: Direct Fuel Rail Pressure rel_fuel_rail_pressure: Relative Fuel Rail Pressure |
GNSS Source | gnss_source | gps: GPS beidou: Beidou galileo: Galileo glonass: Glonass |
|
GPRS Setup | gprs | Setup sending data by GPRS link. Note: after changing this setting device will be disconnected from current server. | apn: APN Name enabled: GPRS Enabled password: APN Password username: APN Username |
GPRS Server Setup | gprs_server | Setup server to send data by GPRS link. Note: after changing this setting device will be disconnected from current server. | host: Host port: Port |
Home GSM Network Settings | home_network | Data acquisition parameters for home GSM network. | on_move: Vehicle Moving on_stop: Vehicle On Stop |
Ignition Detection Source | ignition_detection | Ignition source is configurable and used to determine vehicle ignition status. Ignition status is used in power management and the following functionalities: eco driving, excessive idling, fuel consumption, over speeding, towing and trip. | ign: Ignition source |
LED Indication | led_indication | enabled: Enabled | |
Motion Detection Source | motion_detection | Object motion detection is to be configured to determine device working mode. Other functionalities that depend on movement source are: power manager, fuel consumption and trip. | source: Movement Source |
Odometer | odometer | Enable odometer | enable: Odometer |
Records Parameters | records_params | Records sending parameters setup. | order: Records Soring Order online: Open Link Timeout response: Server Response Timeout |
Roaming GSM Network Settings | roaming_network | Data acquisition parameters for roaming GSM network. | on_move: Vehicle Moving on_stop: Vehicle On Stop |
Sleep Mode | sleep_mode | Device power saving mode setup. In sleep mode module reduces level of power consumption by turning GPS module to sleep. In deep sleep mode module turns GPS module to sleep and device is deregistered from GSM network (device don't receive SMS in deep sleep). In Online Deep Sleep mode device works as in Deep Sleep mode, but without deregistering from GSM network. | mode: Sleep Mode |
SMS Authentication | sms_auth | Authentication credentials for sending commands over SMS | login: Login password: Password |
Static Navigation | static_filter | Static Navigation Mode is a filter, which filters out track jumps when the object is not moving. | stat_nav: Static Navigation |