Teltonika FMB962

Teltonika FMB962 is a smart GLONASS/GPS tracker featuring extensive technology support (Bluetooth, SMS, GPRS, crash detection, idling detection) and a long-lasting Ni-MH battery (up to 3 days).

Title Name Description Properties
Secondary GPRS Server Setup backup_server host: Host

mode: Mode

port: Port

protocol: Secondary GPRS server protocol
CAN Parameters can_params CAN parameters setup. maf: Mass Air Flow Rate

cmd_egr: Commanded EGR

dtc_num: Number of DTC

abs_load: Absolute Load Value

air_temp: Ambient Air Temperature

oil_temp: Engine Oil Temperature

throttle: Throttle Position

egr_error: EGR Error

fuel_rate: Engine Fuel Rate

engine_rpm: Engine RPM

fuel_level: Fuel Level

intake_map: Intake MAP

engine_load: Engine Load

time_mil_on: Time Run With MIL On

bar_pressure: Barometric Pressure

battery_life: Hybrid Battery Pack Remaining Life

coolant_temp: Coolant Temperature

distance_mil: Distance Traveled Since MIL On

fuel_pressure: Fuel Pressure

vehicle_speed: Vehicle Speed

module_voltage: Control Module Voltage

timing_advance: Timing Advance

fuel_inj_timing: Fuel Injection Timing

intake_air_temp: Intake Air Temperature

short_fuel_trim: Short Fuel Trim

run_engine_start: Run Time Since Engine Start

time_codes_clear: Time Since Trouble Codes Cleared

distance_codes_clear: Distance Traveled Since Trouble Codes Cleared

abs_fuel_rail_pressure: Absolute Fuel Rail Pressure

dir_fuel_rail_pressure: Direct Fuel Rail Pressure

rel_fuel_rail_pressure: Relative Fuel Rail Pressure
Crash Detection crash Crash detection scenario settings sms: Send SMS

prio: Priority

trace: Crash Trace

duration: Duration

threshold: Threshold
Firmware Over The Air web serivce fota web: Enable
GNSS Source gnss_source gps: GPS

beidou: Beidou

galileo: Galileo

glonass: Glonass
GPRS Setup gprs Setup sending data by GPRS link. Note: after changing this setting device will be disconnected from current server. apn: APN Name

enabled: GPRS Enabled

password: APN Password

username: APN Username
GPRS Server Setup gprs_server Setup server to send data by GPRS link. Note: after changing this setting device will be disconnected from current server. host: Host

port: Port

protocol: Server protocol
Green Driving green_driving Green driving scenario settings sms: Send SMS

prio: Priority

output: Output Control

source: Source

duration: Duration

max_accel: Max Acceleration

max_angle: Max Angle

max_brake: Max Braking
Phone Numbers gsm_numbers Predefined GMS phone numbers phone1: Phone Number 1

phone2: Phone Number 2

phone3: Phone Number 3

phone4: Phone Number 4

phone5: Phone Number 5

phone6: Phone Number 6

phone7: Phone Number 7

phone8: Phone Number 8

phone9: Phone Number 9

phone10: Phone Number 10
Home GSM Network Settings home_network Data acquisition parameters for home GSM network. on_move: Vehicle Moving

on_stop: Vehicle On Stop
Excessive Idling Detection idling Excessive idling detection scenario settings sms: Send SMS

prio: Priority

output: Output Control

record: Eventual Records

move_time: Move Timeout

stop_time: Stop Timeout
Ignition Detection Source ignition_detection Ignition source is configurable and used to determine vehicle ignition status. Ignition status is used in power management and the following functionalities: eco driving, excessive idling, fuel consumption, over speeding, towing and trip. ign: Ignition Source
Incoming call action incoming_call action: Action
Digital Input inputs1 Digital input I/O parameters settings avg: Average

low: Low Level

sms: Send SMS

high: High Level

prio: Priority

event: Event Only

operand: Operand
Jamming with timeout scenario jamming_timeout mode: Scenario priority
LED Indication led_indication enabled: Enabled
Motion Detection Source motion_detection Object motion detection is to be configured to determine device working mode. Other functionalities that depend on movement source are: power manager, fuel consumption and trip. source: Movement Source
Network Time Protocol server ntp_server mode: Synchronization Source
Odometer odometer_fmb Set odometer mode and initial value value: Initiate odometer value

source: Calculation source
Tracking on demand mode on_demand_mode Push device to start to generate high priority records and initiate data sending to server type: On demand tracking mode
Tracking on demand timing on_demand_params "Tracking on demand: period and duration parameters" period: Tracking period

duration: Tracking duration
Digital Output outputs1 Change state of digital output out1: Output
Overspeeding overspeeding Overspeeding scenario settings sms: Send SMS

prio: Priority

output: Output Control

max_speed: Max Speed
Records Parameters records_params Records sending parameters setup. order: Records Soring Order

online: Open Link Timeout

response: Server Response Timeout
Roaming GSM Network Settings roaming_network Data acquisition parameters for roaming GSM network. on_move: Vehicle Moving

on_stop: Vehicle On Stop
Sleep Mode sleep_mode Device power saving mode setup. In sleep mode module reduces level of power consumption by turning GPS module to sleep. In deep sleep mode module turns GPS module to sleep and device is deregistered from GSM network (device do not receive SMS in deep sleep). In Online Deep Sleep mode device works as in Deep Sleep mode, but without deregistering from GSM network. mode: Sleep Mode
SMS report sending parameters sms_reports phone: Predefined Phone Number Index

enable: Allow sms data sending
Static Navigation static_filter Static Navigation Mode is a filter, which filters out track jumps when the object is not moving. stat_nav: Static Navigation
SMS event Time Zone timezone_sms half_tz: Half Time Zone

time_zone: Time Zone

hemisphere: Hemisphere
Towing Detection towing Towing detection scenario settings sms: Send SMS

call: Call

prio: Priority

angle: Angle

record: Eventual Records

act_time: Activation Timeout

duration: Duration

evt_time: Event Timeout

threshold: Threshold
Unknown GSM Network Settings unknown_network Data acquisition parameters for unknown GSM network. on_move: Vehicle Moving

on_stop: Vehicle On Stop
Unplug Detection unplug Unplug detection scenario settings sms: Send SMS

mode: Mode

prio: Priority

record: Eventual Records